Universal Carrier Mk.I w/Crew
Riich Models 1:35 Scale Kit No. RV35011
Page 1 of 5
Note: All the assembly images are with the kit assembled basically as per instructions with just a few alterationssuch as the rear hull panel but I have suggested an easier way of assembling and fitting the seats in the review text
but the images show the interior and seats as per instructuions .
Ford V8 engine assembly
Inside hull fuel tank assembly. Tanks are made up of 4 parts already assembled in the images.
Separate small mounting blocks (left), fitted to hull (right) and tanks attached (bottom).
Note the small pin marks on the lower floor don't need to be filled as they are all hidden after assembly so don't waste time on them.
Underside exhaust with etched mountings and plastic pipes.
Etched bracket holes fit perfectly over the raised pins on the hull.
Lower hull front etched bolt strip.
Hull side panels fitted, the fit was spot on without any gaps or filler needed.
See the review text regarding fitting the inner driver's controls, steering linkages and seats before
attaching the hull sides to make life a bit easier.
Exhaust fitted to rear hull plate.
Rear hull panel fitted, it's important to fit the rear hull BEFORE fitting the axle/differential unlike what is shown in the instructions.
It is very difficult to fit the rear hull with the axle/differential already attached.
