Cab interior Details
Head light, windscreen wiper and hood T clip parts

Assembled head lights, note the top blackout light is slightly undersized and the bush guard too "squashed" at the top.
Also note the flush screws missing from the radiator louvers and the bolts from the compartment sides.

Attaching the hood hinges, note the pins have been heat welded down to hold the hinges in place.
This adds more strength than just cyanoacrylate as indicated in the instructions.
The pre-assembled hinges were very stiff and hard to fold making opening and closing the hood rather difficult.

Overview of the hood panels fitted in place, the fit is quite good but there are a few minor gaps
Also note the solid grad handles on the hood doors that will look better if hollowed out or replaced.

Overall view of the engine compartment fitted to the lower floor/fenders and too the chassis show a good fit of these
parts not requiring any trimming, there are two screws holding the back of the cab floor to the chassis ensuring everything is aligned correctly.

< Back | Next >