PMMS
Blast Models
US TD M10 Late Stowage
1/35 #BL35064K
Review by Terry Ashley
This stowage set is designed for any of the Academy or AFV Club M10 TD kits with later type turrets and consists of six pieces in light cream resin with the quality of the casting being excellent without any blemishes and only very small pour points and minor seam lines to trim off the parts and also the larger parts are hollowed out and not the usual solid block of resin which reduces their weight.

The detail on the castings is very realistic with well defined details and folds on the bedrolls, tarps etc and crisp details on the other equipment included.

There is a large casting designed to go on the rear of the engine deck and has wooden boards with good wood grain effect on the bottom and one side to hold the load together with two other groups of packs and rolls designed to fit the turret sides and a large tarpaulin roll plus a couple of individual packs to either hang from the front light guards as often seen or anywhere else you wish.

Conclusion:
A simple but nicely detailed set to add life to your M10 kit and while designed for the Academy or AFV Club kits they could probably be used on any other kit with relatively flat plates with just a minimum of trimming.

Highly recommended.

Resin parts
Blast Models

Thanks to Gilles from Blast Models for the prompt delivery of the set.
The kit can be purchased direct from Blast Models or from AFV Modeller Shop in the UK.


Page created 8 April 2005

Click Browsers BACK button to return to list
Home / Reviews / Vehicle Reviews / Blast