M4A2 Mid-Production
with Welded Drivers Hoods
1/35 #F008
Review by Terry Ashley
To remove the thick plug in the turret ring I firstly drill a series of holes
using a hand held pin vice, this results in less resin dust than using a power
tool.
Next snap out the centre resin disc.
Trim the excess resin for a smooth finish.
Note the excellent fit of the Academy engine bay doors, there is no need to
remove the resin inside the engine door recess unless you plan on adding an
engine.
The same method was used for the hull hatch openings.
Home / Reviews / Vehicle
Reviews / Formations